What the paint and flags on your lot mean

Red, yellow, orange, blue, green, purple, pink, and white, and what each one tells a crew about the ground. Click a line on the sample lot and read it.

What do the paint and flags on my lot mean?

Each color is a type of utility. The colors come from a national code, and a locator paints them where the utility's line runs, so anyone digging knows what is underneath. Red is electric, yellow is gas, orange is communications, blue is water, green is sewer, purple is irrigation, pink is survey, and white is where the dig itself is planned.

The code is the American Public Works Association uniform color code. Here it is in full, then a tool you can click through.

WhiteProposed Excavation
PinkTemporary Survey Markings
RedElectric Power Lines, Cables, Conduit and Lighting Cables
YellowGas, Oil, Steam, Petroleum or Gaseous Materials
OrangeCommunication, Alarm or Signal Lines, Cables or Conduit
BluePotable Water
PurpleReclaimed Water, Irrigation and Slurry Lines
GreenSewers and Drain Lines

Digging in Georgia starts with 811. See trenching and utility lines for how we use these marks on a job.

What does each line mean for the dig?

Click a line on the lot

This sample lot has a line of every color. Click a line, a flag, or a color chip to read what it is and what we do about it.

The tool shows what each color is and what we do when we find it on a lot. It is a guide, not a map of your property. Your marks will be in different places.

How do you get lines marked before digging?

Call 811, or file a request with Georgia 811, at least two business days before the dig. The request goes to every member utility with lines near your address, and each sends a locator.

It helps to paint the dig area white first. The marks tell the locator where to look, and the contractor and the locator are working from the same outline. We do that with you at the estimate.

If a utility has no line near your dig, it will say so. A "no conflict" reply is still information, and we keep it on file.

What do the utilities not mark?

Utilities mark their own lines. They do not mark yours. On a typical Augusta lot, that leaves a list of things buried where nobody has painted a line: the sprinkler system and its valve boxes, the wire to a well pump or a barn, the pipe to a shop or a pool, a buried downspout, and in some neighborhoods, old septic lines.

We ask about every one of them at the walk-through. If you do not know what is under the yard, say so. We probe, look for valve boxes and cleanouts, and slow the work near anything we cannot account for.

What are the limits of locate marks?

Georgia 811 describes the marks as approximate line locations. They do not give depth, and a line may have shifted since it was installed. Marks fade, and lines get added after a locate is done.

So the paint is a warning, not a drawing. We treat it that way:

  • We expose a marked line by hand before the bucket gets close.
  • We keep machines off the paint until the line is seen.
  • We stop if something turns up that no mark explains.

How we use locate marks on a job

  1. Outline the dig

    We paint the planned dig white with you at the walk-through.

  2. Place the request

    We call 811 and give the address and the outline.

  3. Read the marks

    When the locators have been, we walk the lot and match the paint to what you know.

  4. Expose and dig

    Marked lines are hand-exposed, then the work goes on around them.

Utility locate questions in Augusta

What do the colored flags and paint on my lot mean?
They are utility locate marks, using a color code published by the American Public Works Association. Red marks electric, yellow marks gas and oil, orange marks communications, blue marks drinking water, green marks sewer and drain lines, purple marks reclaimed water and irrigation, pink marks temporary survey points, and white marks the proposed excavation. Click a line on the sample lot above to read what each one means for the dig.
How do I request a locate in Georgia?
Call 811 or file a request with Georgia 811. The organization asks for at least two business days of notice before digging, so the member utility companies can send locators to mark their lines. We place the request for work we do. If you are digging yourself, you place it.
Are the marks exact?
No. Georgia 811 describes what locators mark as the approximate location of lines, so a line can sit a little off the paint, and the marks say nothing about depth. That is why a careful crew hand-exposes a marked line before the bucket gets close.
Does 811 mark my sprinkler lines and well wire?
The member utility companies mark their own lines. A sprinkler system, a well wire, or a pipe to an outbuilding usually belongs to the property owner, so tell your contractor where they run. If you do not know, say so, and we will look for valve boxes and wire before we dig.
How long do the marks last?
They fade, get mowed over, and wash out. If a locate was requested months ago, treat the marks as out of date and call again. Georgia 811 will issue a new request, and the cost of a second call is nothing against a cut line.
What should I do with the marks on my lot?
Leave them alone until the work is finished. Do not mow over flags or pull them. If a flag is knocked down, tell us before we dig there, and we will have it re-marked.

Related guides

Call nowFree estimate